PRODUCTS

undefined
+
  • undefined

SH-02G efficient mold release agent (high-grade tire)


Classification:


The company specializes in the production of rubber tires, rubber products and friction materials vulcanized release agent (release agent), the current products are film release agent, capsule release agent, mold release agent, tire modification agent, inside (outside) spraying agent and other five series, more than 20 products

Key words: release agent, release agent

Product Details

Use:

SH-02G efficient mold release agent is a water-based solvent environmental protection products. Suitable for all kinds of tire steel mold demoulding. The use of SH-02G high-efficiency mold release agent can play an efficient mold release effect, and at the same time form a protective film on the surface of the mold, so that the mold surface has a good slip, to a certain extent, improve the fluidity of the rubber compound in the mold, and reduce the tire The lack of glue on the surface can effectively improve and improve the appearance quality of the tire. Due to the use of SH-02G and efficient mold release agent, it will not cause any pollution to the mold, nor will it cause color difference on the tire surface, and can extend the cleaning cycle of the mold, greatly improving the production efficiency.

Method of use:

1. mold for the first time to use:

The new mold must be cleaned, especially to completely remove the oil.

2, used old mold reuse must also be cleaned.

3. After the mold is installed, preheat for 2 hours (or reach the temperature specified for tire vulcanization).

4. Spray the mold release agent evenly on the pattern and sidewall parts required to be sprayed on the mold with an air pressure atomization spray gun (generally, AB vulcanizer is sprayed on the lower mold, and B and C vulcanizers are sprayed on the upper mold). It is not necessary to spray the upper and lower molds at the same time.

5, the usual car tire per mold spray amount of about 10 grams, light truck tire per mold spray amount of about 15 grams. For larger tires or off-road tire patterns and patterns that are difficult to start models, the spray amount can be appropriately increased to more than 20 grams per model.

6. Repeat spraying once at intervals of about 5 minutes according to the above spraying amount and method.

Continuous use 2. daily production:

1, in the normal production of tire vulcanization, every 4 hours to fill the spray once, (estimated at the frequency of 20 mold). In case of special pattern or light truck pattern, it should be sprayed once every 2 hours.

2. The method and quantity of supplementary spraying are the same as those of the first spraying.

3. This product can be used in appropriate increments for patterns with greater difficulty in demoulding, which can significantly improve the demoulding effect, but will not affect the appearance quality of the tire, nor will it cause any pollution to the mold.

Product recommend

Online Message

If you are interested in our products, please leave us a message and we will contact you as soon as possible!